Shandong hot water pressure washers, pressure washer Mahathir electric heating, separate boiler fan motor, cold water only when the device is working, the fan motor does not start, heating fuel pump does not work, relatively reducing the failure rate, extending the life. Heating switch off after 20 seconds to stop the fan motor delay, in order to clear the boiler exhaust gas and dust, while a cooling effect. Heating switch is turned on, the fan motor driven pump to work, the auto-ignition delay of 3 seconds, so the ignition of fuel oil is sufficient to more fully reduce startup emissions. Conventional equipment such function, resulting in higher exhaust gas ignition, combustion is not sufficient. The bottom of the oil-fired boiler has a 7 cm thick cushion of special material that is easy to fall into the furnace fuel burn cleaner, reached an automatic cleaning effect. Long professional experience in boiler fuel production, the unique structural design, high heating efficiency, low fuel consumption, only 6 liters per hour. Technical data MH 28/18 maximum pressure bar / MPa / PSI 0-280 / 0-2 / 0-4060 maximum flow rate l / h 1080 drive volts / phase / Hz 380/3/50 power 11.25 kW maximum water temperature 80 degrees Celsius / 155 rpm rev / 1450 Weight 120 kg Dimensions L * W * H mm 1278X878X800 grip trigger automatic gun high pressure hose 10 m 1.2 m 15 degrees Applications 1. 2. Builders Concrete Cement cleaning rotary kiln and equipment minute Cleaning roughening / surface coating removal. 3. The large internal surface cleaning cleaning and maintenance during transport. 4. lossless clear sand casting surface. 5. The surface cleaning and surface ships except paint rust. 6. heat exchanger and condenser routine cleaning and dredging. 7. automobile factory paint shop floor grille and body spray paint removal skid plate